Microelectronic NH MicroM30/12 HDMI USB Especificaciones descargar pdf (Pagina 19)

Connecting the receiver

The receiver is connected with your satellite antenna by

means of a coaxial cable. If necessary, you have to

prepare a coaxial cable before connecting the receiver.



The coaxial cable is not included in the scope of

supply.

Caution!

Connect the receiver to the mains supply only after you

have connected it to all equipment and the antenna

properly. Otherwise, there is a risk of electric shock

that can be a threat to life or physical condition. Also

the receiver can suffer damages.

Caution!

Information on separation from power source. The

Standby key of this device will not separate the device

completely from the power source. In addition, the

device will draw current. To separate the device

completely from the power source, the mains plug

must be pulled out of the socket.

The wire netting and the inner core of the coaxial cable

carry current during operation.

Caution!

Camping or trailer operating:

The receiver can also be connectet to 12 Volt ( viz. 11-

14 Volt, e. g. solar collector, motor vehicle). To do this,

use the 12 Volt cable.

Caution! For using vehicles with 24 volt on-board

voltage (eg, trucks), you have to use a 24V / 12V DC /

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 94 95

Sin comentarios

Microelectronic NH MicroM30/12 HDMI USB Especificaciones Pagina 19